XCADEY Power Meter Bicycle Computer Power Meter Crank Bluetooth GPS
Free shipping by EMS
X-POWER DYNAMOMETER / WATTOMETER QUICK START / USER GUIDE
1. Turn the battery / cover cover counterclockwise to the question mark;
2. open the cover / cover and charge the battery;
3. aiming at the dot mark to cover the cover;
4. Turn the cap clockwise.
Please be aware that throughout this process, do not lose or damage the waterproof rubber ring.
CORRESPONDENCE / PAINT SENSOR
1. wait for 2 minutes after installing the battery until the blue light on the dynamometer starts blinking;
2. search for the device when turning on the dynamometer meter sensor option, until it appeared "found dynamometer"
We suggest that you calibrate the device each time before use.
1. several circles turn the crank, and make sure the crank is vertical to the floor, keep your hands and feet off the crank,
Stay still for 2 seconds;
2. Enter the calibration interface gauge dynamometer, and click "" until it appeared "OK" calibration calibration;
3. Calibration Fails If the value indicator returned is "0". Please repeat the above calibration procedure procedure.
Working voltage: DC-3V
Battery Mode: CR2032
Battery life: 150 hours
Wireless frequency: 2.4 ghz
Waterproof level: IP66
Operating Temperature: -10-50 ℃
FC5800: 172.5mm 170mm 175mm
FC6800: 170mm 172.5mm 175mm
FC9000: 172.5mm 170mm 175mm
= Icycle Power Meter Energy Meter Crank Bicycle Computer GPS Garmin Edge Bryton IGPSPORT ANT + Bluetooth Support
The most common power meter crank, which basically contains a series of tensiometers, measures the magnitude of the force applied by the cranks by cranking, and then detects the movement frequency of the pilot by means of a magnetic induction element or accelerometer , which is received by the electronic component, Transfer to a cycling computer for the cyclist's vision!
The protagonist is released unilateral crank power meter, install crank power meter, please use the laser equipment to install the fire area, smooth paint, and then sticky way to install the power meter components to the crank, the above description is the installation of the power meter components FC-5800/6800/9000 image
Power meter using the most common CR2032 battery, the ideal situation can walk 150 hours, stand up to a year, the working environment -10 ° to 50 °, IPX6 waterproof, waterproof, anti-matter strange
Comparison test, test platform 9000 power meter (red curve) G3 HUB power meter (yellow curve) crank power meter (green), data acquisition, TRAINING + G3 analysis software and data end is very close, in frequency, the feedback curve is very close, the total low-power, 3-point sampling power meter are very close to the whole process without disconnection, loss of data packets, you can be sure that this product is very competitive, cost-effective, suitable for daily training, to increase the level of competition! at the time of purchase, you need to determine the difference between the frame and the crank, You can choose a 6mm wrench, the installation difference should be greater than 6mm, part of the frame if you use hidden brake BB, installation bottom BB of the braking time can not be used.